W2 Infini T wheeled vacuum cleaner for dust, solids and liquids

The chip vacuum is equipped with a cast-aluminum suction unit of the side-channel blower type, in which the impeller is attached directly to the motor shaft, and without transmission systems. This makes it possible to almost completely reduce component wear and the consequent need for maintenance, making the motor particularly suitable for continuous service (even 24 hours a day). In addition, it allows a very high vacuum to be developed, which is higher than transmission systems of similar power.
The control panel of the industrial vacuum cleaner consists of a stop-run control panel, containing a circuit breaker. A vacuum gauge makes it possible to constantly monitor the level of depression and the state of saturation of the filter, and to promptly detect any anomalies.

A double silencer reduces noise and dampens the impact of outgoing air, allowing the vacuum cleaner to be used in places where there are noise regulations.
The turbine is equipped with a vacuum limiting valve. If the maximum vacuum is reached due to occluded pipe it lets ambient air into the turbine to cool it.

Inside the steel filter chamber is the polyester pocket filter, which protects the suction unit, ensures high dust retention and guarantees the purity of the outlet air, thanks to a large surface area (20,000 cm2) and high filtration efficiency (3 microns).
A manual cleaning system, consisting of a vertically moving filter shaker, allows the operator to clean the filter effortlessly at any time, prolonging filter life, preventing filter saturation and consequent reduction in suction performance.
The suction system with Ø50mm nozzle positioned below the filter allows simultaneous suction of dust, solids and liquids without the need to replace or remove the filter.

The vacuumed material is deposited in a 40-liter capacity, wheel-mounted steel release container that allows for quick and dirt-free disposal of the vacuumed material, with bagging facilities.