With its high vacuum performance
and large filtering surface area
, the M70 vacuum cleaner is the perfect suction solution for the cleaning
sector, with a 100-litre container and accessory holder. One of the most compact in its category, it is suitable for collecting dust, solids, waste or liquids, even simultaneously and for continuous use
The industrial vacuum cleaner is equipped with a cast aluminium suction unit of the side channel blower
type, in which the impeller is attached directly to the motor shaft, and has no transmission system. This almost completely reduces component wear and the resulting need for maintenance. These features, together with the low noise level
, make the motor particularly suitable for continuous operation (even 24 hours a day), and allow it to develop a very high depression value, higher than transmission systems of similar power.
The control panel of the industrial vacuum cleaner consists of a push-button panel with a magnetothermal switch. A vacuum gauge
is used to constantly check the vacuum level and the filter saturation status, and to interrupt suction in the event of any anomalies. A double silencer
reduces noise and lowers the impact of the outgoing air.
Cat. "L" polyester filter
with filtration efficiency down to 3 microns.
There is no need to remove the motor head and filter from the vacuum cleaner to empty the collection container, which is fitted with a clever lever system that allows it to be quickly released.
The manual cleaning system with a vertical filter shaker lever
allows the user to clean the filter effortlessly at any time. This prolongs the life of the filter, preventing it from becoming saturated and maintaining the suction performance of the vacuum cleaner constant. The front suction system with a Ø80 cast aluminium inlet positioned below the filter allows simultaneous vacuum of dust, solids and liquids
(within the container capacity) without the need to replace or remove the filter.
A quick-release, wheeled steel container (100 litre capacity
) allows swarf, scrap and dust to be disposed of quickly and without getting dirty, with the possibility of bagging.
Also available in atex certified version
Available model in PN version
with an effective filtration system consisting of large filter surface cartridges with innovative automatic pneumatic cleaning system. Particularly suitable for treating very fine dust
and in large quantities
that could clog the common filtration systems at an early stage.